Wasp Bar Code WWS850 用户手册

 

1

 
This manual described how to operate and configure the WWS800/850 Wireless 
Barcode Scanner and is divided into two sections. The first section describes the 
installation, operation and programmable features of the scanner. The second 
section contains the setup barcodes used to configure the scanner. 

•  Barcode Readability: Most popular barcode symbologies are supported including 

the newest RSS Code. 

•  Negative barcodes supported. 
•  Eight scan modes supported. 
•  Programmable Beeping Tone 
•  Dual Color Indicator 
•  Interface Support (base unit): KB Wedge, RS232, and USB 
•  Bluetooth Serial Port Profile Supported: The scanner can transmit scanned data 

to Bluetooth enabled computer/PDA via standard Bluetooth Serial Port 
communication. 

•  Bluetooth HID Supported: The scanner can transmit scanned data to Bluetooth 

enabled computer/PDA via standard HID communication. 

•  Programmable Code ID: Code ID can be individually configured for each 

symbology. 

•  Programmable Length Code 
•  Programmable Prefix Code 
•  Programmable Postfix Code 
•  Character Substitution 
•  Data Editing: Data can be reorganized according to user programmable formats. 

Up to three data editing formats are supported. 

•  Extremely Low Power Consumption 

 

2

 
The WWS800/850 kit contains: 
A WWS800/850 wireless barcode scanner 
A base  
A rechargeable battery 
A Serial/Keyboard/USB Cable (depending on configuration ordered) 
A power supply for the base or the scanner. 
Diskette containing “Scan Manager” and this manual 
 

Bluetooth Serial Port installation and configuration 
instructions. 

 

                          

 

 

Connect the interface cable into the 15-pin connector at the back of the base.  
There are three types of cables available: RS232, Keyboard or USB. 

Power  off your PC or Laptop when connecting the cable to your PC or Laptop. 
Once your cable is connected to the base, plug the other end into the appropriate 
port on your PC. For example, if you have a serial cable, plug it into the com port 
of your PC, if you have a Keyboard cable, plug it into the keyboard port of your 
PC and if you have a USB cable, plug it into the USB port on your PC.  

Connect the power supply provided to your AC outlet and plug the other end into 
the base, then power on your PC. 

Now you are ready to configure your scanner and base.