Konica Minolta TWIN Driver 用户手册
Error messages
5
TWAIN Driver
5-5
Transmission error
Computer display message:
2
Note
The network cable can be used only when the optional network interface
card NC-503 or image controller IC-206 is installed.
card NC-503 or image controller IC-206 is installed.
Scanning
Computer display message:
Cause
Remedy
The machine has not started up.
• Turn off the machine, and then check
that the USB cable and network cable
are correctly connected.
are correctly connected.
• After checking the USB cable and net-
work cable, turn on the machine again.
• If the error is still not corrected, contact
your technical representative.
A system crash may have occurred on the
computer or the machine during transmis-
sion.
computer or the machine during transmis-
sion.
The USB cable or network cable was not cor-
rectly connected during transmission.
rectly connected during transmission.
Cause
Remedy
If a TWAIN scan job is sent at the same time
as a copy job, the machine may stop while
scanning.
as a copy job, the machine may stop while
scanning.
Wait until the copy or scan operation is fin-
ished.
ished.