Canon XRD9827REF 用户手册

 

 

 

 

 

 

 

5

How to Run the XRD9827REF Demonstration 
 
1.  Make sure the computer is powered off and the AC power adapter is disconnected from a wall outlet 
2.  Connect the parallel port cable to the printer port of the computer  
3.  Connect the AC power adapter into a wall outlet 
4.  Turn on the computer and activate Windows 95  
 
Loading EXAR Software 
 
5.  Load the diskette labeled SenseIt 1.0 Disk # 1 into the floppy drive 
6.  Select the Start menu in the program manager and choose RUN 
7.  Inside the small pop-up window, type:  A:\setup 
8.  Follow the instructions to finish software installation 
 
Parallel Port Configurations 
 
9.  Confirm the parallel port address as follows: 
 

I. 

Select the Start Menu, choose Settings, then choose Control Panel 

 

II. 

From the Control Panel window which pops up, double-click on System 

 

III.    

In the System Properties window, select Device Manager 

 

IV. 

From the Device Manager window, double-click on Ports (COM & LPT) 

 

V. 

Double-click on Printer Port (LPT1). If you can not find it, please goto Step 10 

 

VI. 

From the pop-up window, select Resources 

 

VII. 

Verify the Input/Output Range is set to 0378 - 037F 

 

VIII. 

If the range is not correct, clear the Use Automatic Settings check box by clicking it 

 

IX. 

Choose correct address which is 0378 by default and click OK 

 

X. 

Re-start the computer as advised 

 
10.  If you do not have a Printer Port configured on your computer, please follow the steps listed below: 
 

I. 

From the Control Panel window which pops up, double-click on Add New Hardware 

 

II. 

From the pop-up window, click the Next > button 

 

III. 

Select ‘No’ when prompted for ‘Do you want Windows to search for your new  

 

 

hardware?’, then click the Next > button 

 

IV. 

Choose Ports (COM & LPT), then click the Next > button 

 

V. 

Choose Printer Port, then click the Next > button 

 

VI.  

Make a note of the Input/Output Range of Printer Port of your computer and click OK.  

 

 

You will use these values later when configure the SenseIt software 

 

VII.   

Re-start the computer as advised 

 
Offset Adjustment With a Black Target 
 
11.  Set the dip switches located on the side panel of the scanner to [110 01000000] as shown in Figure 3 
and push the Serial Port button which is located on the front panel of the demo system. This will reset the 
XRD9827.