Böwe Bell+Howell 1400U 用户手册

 

 

 

 
 
Multifeed Ignore (1400u Only) 
When double feed detect is set to stop(the default setting) you can enable the Multifeed Ignore 
Functionality 
 
Multifeed Ignore enables you to allow a single page to go through the scanner without having the scanner 
stop for a multifeed condition. Multifeed Ignore can be used with envelopes, documents with attached 
notes, documents with photographs or any other document that is comprised of two overlapping items. The 
Multifeed Ignore function works for only the top document in the scanned batch, once the scanner has 
been set up for Multifeed Ignore. If you require multiple documents to go through the scanner that will 
trigger the scanner to stop because of a multifeed, consider modifying the multifeed settings. Refer to 

“Detect Double Feed” 

for instructions on how to do this. 

 
If a multifeed error occurs, remove the document from the ADF (Automatic Document Feeder) by opening 
the ADF or by pressing the STOP/START button. 
 
Press and hold the STOP/START button for 2 seconds until the LED light alternates between green and 
orange. When this occurs, the scanner is in Multifeed Ignore mode. Re-insert the document in which you 
want to ignore the multifeed on top of the document stack and place on the ADF. 
 
Either re-initiate the scan within your scanning software, or the scanner will automatically begin scanning 
again. 

 

 
 

ΠNOTE:

 

 
 
The Multifeed Ignore function only works for one document at a time. Once a document goes 
through, the scanner will stop if a new multifeed condition occurs. 
 
To clear the Multifeed Ignore feature, open either the imprinter door, the top of the ADF or the bottom of the 
ADF