Samsung XE500T1CA01VE 用户手册

This product can contain an embedded radio transmitter and 

receiver. It is designed and manufactured not to exceed the 

exposure limits for radio frequency (RF) energy set by the Federal 

Communications Commission (FCC) of the U.S. government. These 

FCC exposure limits are derived from the recommendations of two 

expert organizations, the National Council on Radiation Protection 

and Measurement (NCRP) and the Institute of Electrical and 

Electronics Engineers (IEEE). In both cases, the recommendations 

were developed by scientific and engineering experts drawn from 

industry, government, and academia after extensive reviews of the 

scientific literature related to the biological effects of RF energy. 
The exposure limit set by the FCC for wireless devices employs a 

unit of measurement known as the Specific Absorption Rate (SAR). 

The SAR is a measure of the rate of absorption of RF energy by the 

human body expressed in units of watts per kilogram (W/kg). The 

FCC requires wireless devices to comply with a safety limit of 1.6 

watts per kilogram (1.6 W/kg). The FCC exposure limit incorporates 

a substantial margin of safety to give additional protection to the 

public and to account for any variations in measurements.
SAR tests are conducted using standard operating positions 

accepted by the FCC with the wireless transmitting at its highest 

certified power level in all tested frequency bands. Although the 

SAR is determined at the highest certified power level, the actual 

SAR level of the device while operating can be well below the 

maximum value. This is because the device is designed to operate 

at multiple power levels so as to use only the power required to 

reach the network. In general, the closer you are to a wireless base 

station antenna, the lower the power output. 
Before a new model is available for sale to the public, it must 

be tested and certified to the FCC that it does not exceed the 

exposure limit established by the FCC. Tests for each model are 

performed in positions and locations (e.g. at the bottom on the 

body) as required by the FCC.

For body worn operation, this model has been tested and meets 

the FCC RF exposure guidelines when used with Samsung 

accessory designated for this product. Non-compliance with the 

above restrictions may result in violation of FCC RF exposure 

guidelines. 
SAR information on this and other model can be viewed on-line 

at http://www.fcc.gov/oet/ea/fccid/. This site uses this product FCC 

ID number on the outside of the product. Sometimes it may be 

necessary to remove the battery pack to find the number. Once 

you have the FCC ID number for a particular product, follow the 

instructions on the website and it should provide values for typical 

or maximum SAR for a particular product.