Husqvarna PP 418 用户手册
8
FUEL HANDLING
PROPER FUEL
Taking the following precautions will lessen the risk
of injury and property damage:
of injury and property damage:
- Use extreme care in handling gasoline. It is
extremely fl ammable and the vapors are explosive.
- Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
- Use only approved gasoline containers.
- Never remove gas cap or add fuel with the engine
running. Allow engine to cool a minimum of 3
minutes before refueling.
- Never fuel the machine indoors.
- Never store the machine or fuel container where
there is an open fl ame, spark, or pilot light such as
on a water heater or other appliances.
- Never fi ll containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place con-
tainers on the ground away from your vehicle when
fi lling.
- Remove the power pack from the truck or trailer
and refuel it on the ground. If this is not possible,
then refuel the equipment with a portable container,
rather than from a gasoline dispenser nozzle.
- Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
- If fuel is spilled on clothing, change clothing
immediately.
- Never overfi ll fuel tank. Always wipe off any spilled
fuel or oil. Replace fuel cap and tighten
extremely fl ammable and the vapors are explosive.
- Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
- Use only approved gasoline containers.
- Never remove gas cap or add fuel with the engine
running. Allow engine to cool a minimum of 3
minutes before refueling.
- Never fuel the machine indoors.
- Never store the machine or fuel container where
there is an open fl ame, spark, or pilot light such as
on a water heater or other appliances.
- Never fi ll containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place con-
tainers on the ground away from your vehicle when
fi lling.
- Remove the power pack from the truck or trailer
and refuel it on the ground. If this is not possible,
then refuel the equipment with a portable container,
rather than from a gasoline dispenser nozzle.
- Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
- If fuel is spilled on clothing, change clothing
immediately.
- Never overfi ll fuel tank. Always wipe off any spilled
fuel or oil. Replace fuel cap and tighten
The BRIGGS & STRATTON engine is certifi ed to operate on
unleaded gasoline with a pump octane rating (M+R) of 86 or
higher, or a research octane rating (R) of 91 or higher.
unleaded gasoline with a pump octane rating (M+R) of 86 or
higher, or a research octane rating (R) of 91 or higher.
Refuel in a well-ventilated area with the engine stopped.
You may use regular unleaded gasoline containing no more
than 10% ethanol (E10). Do not use gasoline containing
methanol.
than 10% ethanol (E10). Do not use gasoline containing
methanol.
Use of fuels with an ethanol content of more than 10% (E10)
may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system, as
well as posing a fi re hazard.
may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system, as
well as posing a fi re hazard.
Do not use fuel that is older than 30 days. Old fuel can cause
running problems as well as fuel system damage.
running problems as well as fuel system damage.
The engine will not operate on gasoline
marketed as E-85 (85% ethanol)
marketed as E-85 (85% ethanol)
OIL HANDLING
WARNING
Used oil is a hazardous waste product. Dispose
of used oil properly. Do not discard with household
waste. Check with your local authorities, service
center, or dealer for safe disposal/recycling facility.
waste. Check with your local authorities, service
center, or dealer for safe disposal/recycling facility.
NOTICE
ENGINE OIL
Oil Recommendation
The engine holds approximately 1.4 liters (1-1/2 qts - 48 ounc-
es) when changing oil and oil fi lter.
The engine holds approximately 1.4 liters (1-1/2 qts - 48 ounc-
es) when changing oil and oil fi lter.
- Use a high quality detergent oil classifi ed “For Service
SF, SG, SH, SJ” or higher.
- BRIGGS & STRATTON strongly recommends the use
of Synthetic oil.
- Do not use special additives.
- Choose a viscosity according to the table below.
SF, SG, SH, SJ” or higher.
- BRIGGS & STRATTON strongly recommends the use
of Synthetic oil.
- Do not use special additives.
- Choose a viscosity according to the table below.
Use of synthetic oil does not alter required oil change
intervals.
intervals.
Please read the enclosed BRIGGS & STRATTON Operator’s
Manual for complete oil information.
Manual for complete oil information.
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
SAE VISCOSITY GRADES
-20
0
30
40
80
100
-30
-20
0
20
30
40
F
C
C
32
-10
10
60
5W-30
SAE 30
SYNTHETIC OIL 5W-30, 10W-30
HYDRAULIC OIL
Any high quality hydraulic oil with a viscosity rating of
ISO 46 (46 cSt) can be used.
ISO 46 (46 cSt) can be used.
High quality hydraulic oils that are marketed as
“Biodegradable” can be used with a viscosity rating
equivalent of ISO 46.
“Biodegradable” can be used with a viscosity rating
equivalent of ISO 46.
NOTE:
Biodegradable hydraulic fl uids may require different service
intervals compared to the traditional mineral based oils.
Consult and follow the oil manufacturers recommendations re-
garding the service life of the oil.
Biodegradable hydraulic fl uids may require different service
intervals compared to the traditional mineral based oils.
Consult and follow the oil manufacturers recommendations re-
garding the service life of the oil.
The Hydraulic system is also compatible with some “Food
Grade” oils that can be used for specifi c applications. Please
contact Husqvarna Construction Products for advice.
Grade” oils that can be used for specifi c applications. Please
contact Husqvarna Construction Products for advice.