Festool PI571579 用户手册

11

Press the contact slide down until it latches 

 

f

into position.
Insert the handle section [1-6] at the same 

 

f

way.
If you wish to use the 

 

L

PLANEX

  for sanding 

walls in cramped spaces, for example, reduce 
the length of the machine by fi tting the sanding 
head [1-1] directly to the handle section [1-6].
When disassembling the machine, do not forget 

 

f

to press the button [4-1] to release the contact 
slide before opening clamping levers [3-1] and 
[3-2].

The machine features full-wave electronics with 
the following properties: 

Smooth start-up
The electronically controlled smooth start-up 
function ensures that the machine starts up 
smoothly.

Speed control
You can regulate the rotational speed steplessly 
between 310 and 920 rpm using the adjusting 
wheel [1-3]. This enables you to optimise the cut-
ting speed to suit the respective material.

Constant speed
The preselected motor speed remains constant 
through electronic control. This ensures a uniform 
cutting speed even when under strain.

Insert an Allen key (size 5) into the Allen screw 

 

f

[5-1] on the sanding pad. 
Hold the sanding pad securely and turn the 

 

f

Allen key to release. 
In order to further ensure optimum axial run-

 

L

out, you must fi rst clean the bearing surface 
for the grinding disk on the driveshaft.
Attach the new sanding pad.

 

f

Tighten the screw

 

f

 [5-1].

Only attach specifi ed sanding pads to the ma-

 

L

chine. 
In order to guarantee optimum suction output, 

 

L

the sealing face between the machine and 
the grinding disk is ground in during the fi rst 
few minutes after the disk has been changed. 
During this time, the r.p.m. of the machine is 
slightly lower and white foam particles form 
during the grinding process. However, they do 
not damage the machine.

5-1

5-2