Festool PI571782 用户手册

8

removal (coarse sanding) and polish-

ing.

Slide the switch (6.1) into the right posi-

tion.

  This motion is recommended for 

sanding with low material removal for 

a scratch-free fi nish (fi ne sanding).

Press the switch (6.1) down and push it into 

the left-hand position.

Choice of sanding pad
The tool can be fi tted with three sanding 

pads of different hardnesses depending on 

the surface to be sanded.
Hard: Coarse sanding on surfaces, sanding 

at edges.
Soft: Universal use for coarse and fi ne 

sanding for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts, 

curves, radii. Do not use on edges!

Installation
The FastFix system enables tool-free re-

placement of the sanding pad:
- Set the switch (7.1) to the right for the 

Rotex rotary motion,

- Press spindle stop (7.3), direction of move-

ment fi rst to the side, then forwards,

- Turn the fi tted sanding disk (7.2) from the 

spindle (right-handed thread),

- Keep the spindle stop pressed and screw 

on the new sanding pad (in doing so, make 

sure that the rubber collar (10.1) is cor-

rectly fi tted!),

- Let go of the spindle stop.

 Actuate the spindle stop only 

when the drive spindle is stationary. Do not 

switch on the motor when the spindle stop 

is pressed in.