Multiquip FS2SP 用户手册

Figure 5 displays the location of the various operational control
features of the FS2/FS2SP saw. Features are dependent on the
specific model saw selected. The function of each console component
or indicator is explained below:

1.

 

Push this stop button to stop

the engine. Also acts as a fast and secure way to stop the
engine in the event of an emergency.

2.

 Forward

locking position engages transmission. Rear Locking
position disengages transmission from rear axle and
permits "free wheeling" (self-propelled models Only).

3.

 On position 

opens valve and

permits water to flow from source through saw water hose.
OFF position 

closes valve and halts the flow of water.

4.

 

Pull the lever to increase engine RPM.

Push lever to decrease engine RPM (electric start models
only).

5.

 

Pull lever to assist when starting a cold

engine. 

Push lever down after engine warms to disengage

choke (electric start models).

6.

 Auxiliary switch for future features

(electric start models).

7.

 Push top of rocker switch to provide  +12

VDC power (ON) to the external halogen light. Push bottom
of rocker switch to remove (OFF) +12 VDC power from
halogen light (electric start models).

8.

 Push top of rocker switch to provide

(ON) +12 VDC power to the external water pump. Push
bottom of rocker switch to remove (OFF) +12 VDC power
from water pump (electric start models).

9.

 Indicates engine RPM

and number of hours (operation) saw has been in use.

10. Raise/Lower Crank Handle –

 Physically orients saw

(raises or lowers) depending on cranking direction (CW or
CCW). One full turn equals 3/8". Turning the handle
clockwise  lowers the saw, turning the saw counter-
clockwise raises the saw. The raise/lower crank handle is
used in conjunction with the 

depth feed gauge.

11. Start Button –

 A spring loaded button, that when pressed

actuates the engine start solenoid (electric start models
only).

12. Depth Feed Gauge –

 Indicates the blade cutting depth in

inches. To activate, first lower the blade via the 

handle until the blade touches the cutting surface. Then
roll the depth feed dial until the face label reads 

zero.

13. Forward/Reverse Speed Lever –

 Controls forward and

reverse speeds for self-propelled operation. Provides
positive neutral for engine star t. 

ALWAYS place

transmission engage/disengage lever in the engage
position before setting speed lever (self-propelled models
only).

14. Handle Bar Locking Knobs –

 Loosen or tighten these

two knobs when making adjustments to the handlebar(s).
Turn handle(s) 

counter-clockwise to loosen and

clockwise to tighten.