Husqvarna K 3600 MKII 用户手册

English

 – 19

The blade does not rotate.

Roller knobs not tightened fully.

The blade not fitted on guide rollers correctly.

Rollers tensioned too much.

Possible faulty hose connection to the hydraulic system.

Possible faulty hose connection to the drive source or other hydraulic problem.

The blade rotates too slowly.

Roller knobs not tightened fully.

Worn drive wheel.

The V-shaped inner diameter of the blade is worn.

The springs on the guide rollers are weakened.

Dirty overpressure valve in the hydraulic system.

Valve knob on the hydraulic motor does not move the correct distance.

Defective roller bearings.

Inadequate oil flow, check the hydraulic oil flow.

The blade jumps out of its position. Roller setting too loose.

Worn guide rollers.

The blade not fitted on guide rollers correctly.

Damaged blade.

The blade warps.

Rollers tensioned too much.

Blade overheating.

Segments break.

Bent, twisted or badly maintained blade.

The blade cuts too slowly.

Wrong blade for the material in question.

Check that the right amount of water reaches the blade.

The blade slips.

The guide rollers does not move in and out freely. A seized roller can not press the blade hard 
enough against the drive wheel.

Worn drive wheel. Abrasive material and too little water when cutting increases the wear on 
the wheel.

Worn guide roller flange. When more than half of the width of the flange is worn the blade 
slips.

The blade’s groove and inner edge are worn. Caused by inferior flushing of abrasive material 
and/or a worn drive wheel causing the blade to slip.