Husqvarna 544 93 62-01 用户手册

0  SpeedMill

Allow SpeedMill Bowls to cool before performing any main-

tenance.

DO NOT hold SpeedMill Bowls using a screwdriver or 

other device through the slots in the bowl.  Damage to 

the bowls or abrasive coating could occur. 
DO NOT use a screw driver or similar in the slots of the 

SpeedMill Bowls to lock the blade.  If you do it is likely 

the flanges will be damages and become unusable.
Use the proper procedure to lock the blade when at-

taching or removing the blade or flanges – See below, 

or see K750 Operation Manual.

  

When removing the Hub nut, 

use a Screwdriver to lock the 

blade shaft in position.  Push 

the screwdriver into the slot 

(see picture) and rotate the ar-

bor until the screwdriver stops 

the rotation.

The parts required for the SpeedMill Accessory are shown 

on the next page.  For any other parts used on this ma-

chine see the power cutter spare parts list (included).

  

Plastic debris from a small-

er flange often lodges itself 

in the bigger flange during 

cutting.  This can easily be 

removed once the flanges 

have cooled down.

  Use compressed air to 

blow shavings from Speed-

Mill Bowl.  DO NOT scrap 

shavings from bowl using 

a screwdriver or any other 

hard metallic tool.  Damage 

to the bowls or abrasive 

coating could occur.

Inspect the SpeedMill Bowls
Always inspect the SpeedMill Bowls before you start cut-

ting.  Small nicks or scratches can be sanded smooth.  If 

the SpeedMill Bowl has been bent or distorted in any way it 

must be replaced.
Cleaning

NEVER use the SpeedMill as a regular power cutter!

The guard on the SpeedMill is designed to work together 

with the special outer flange and SpeedMill Bowls used 

on the SpeedMill.  The 8” (200mm) SpeedMill Bowl must 

always be installed when the SpeedMill is used and the 

SpeedMill shall not be used for any other purpose than 

those mentioned in “USES” section of this document.

Should you desire to convert the SpeedMill to a regular 

power cutter you must replace the cutting head with an 

original 12” or 14” cutting head attachment.  We recom-

mend you have an authorized dealer do the conversion.