Husqvarna FS 413 用户手册

PARTS IDENTIFICATION (WHAT IS WHAT)

AA. Emergency Stop Switch: Depress Switch to STOP

engine in emergencies. Reset by pulling outward (pull up)

to allow re-starting of machine.
BB. Tool Compartment: Contains Operation Manual,

Parts List, & two wrenches (T & U) (mm & mm).

Open by turning knob 80 degrees. Always return Opera-

tion Manual to this area for future reference.
CC. Engine Throttle: Controls Engine speed (RPM).

Push forward to increase engine speed. Pull backwards

to decrease engine speed. All sawing is done at maxi-

mum engine speed.
DD. Engine Start Switch: Located on engine, behind

Front Cover (V). Must be ON () to start engine. Use to

turn engine OFF (“0”) in non-emergency situations.
EE. Blade Depth Control: Turn Counter-Clockwise to

raise Diamond Blade (H) and Clockwise to lower Diamond

Blade (H).
FF. Blade Depth Stop: To Lock Blade Depth Control (EE)

in position. Pull Blade Depth Stop toward rear of machine

and turn 90 degrees to lock in open position.
GG. Blade Depth Indicator: Shows cutting depth of Dia-

mond Blade (H) in centimeters (orange color) and inches

(white color). Operation: With engine OFF (“0”), lower

Diamond Blade (H) until in contacts the cutting surface.

Rotate Blade Depth Indicator to align “0” with arrows.

Raise Saw. When saw is lowered into cut, current cutting

depth is shown.
HH. Engine Tachometer (RPM): Shows engine speed in

revolutions per minute if engine is running. Shows total

operation time when engine is OFF (“0”). Total operation

time shown in minutes from 0-9 minutes, and hours for

0+ minutes.

II. – – –
JJ. Rear Handle: Operator position is behind machine

with both hands on Rear Handle. Handle is adjustable to

several positions.
KK1. Water Control Valve: Controls water flow to blade.

Located on Left side of machine, near Rear Handle (RR).

Not used with the water tank (if equipped).
KK2. Blade Guard Water Control Valve: Controls the

water flow to the blade. Located on blade guard. Used

with water tank (if equipped).
LL. Belt Guard (Not Shown): Covers engine drive belt.
MM. Belt Drive Idler: Used to hold tension on Blade

Shaft Drive Belt.
NN. Oil Drain Hose: Use to remove oil from engine.
OO. Parking Brake (EU units only): Use to hold ma-

chine in parked position. Located at Right Rear Wheel,

at rear of machine. Operation: To engage, rotate lever

upward, so rod is allowed to move inward. To dis-engage,

pull rod inward and rotate downward so rod is fixed in the

inward position.