Husqvarna FS 413 用户手册

8

Install Water Tank (P) (if equipped): 

• A factory installed water tank is available in some 

regions.  An optional water tank kit is available for all 

regions.

• If water tank was previously installed on machine, read 

these instructions to verify that installation is correct.  Fol-

low all WARNINGS for installation and use of the Water 

Tank.

• Verify the contents of the Water Tank Kit See Diagram at 

right.

Torque NUT as specified, else failure of LIFTING EYE 

(O) could occur.  Injury or death could occur if LIFT-

ING EYE fails while lifting machine.

. Temporarily remove the right hand (same side of ma-

chine as engine starter rope) NUT from Lifting Eye (O).  

See diagram at right.

. Install CLAMP supplied in Water Tank Kit (P), and then 

reinstall the NUT.  See diagram at right.

3. Torque as specified below, and diagram at right.