Husqvarna K 970 用户手册
English
– 17
STARTING AND STOPPING
Before starting
•
Perform daily maintenance. See instructions in the section
"Maintenance".
"Maintenance".
Starting
•
Decompression valve: Press in the valve to reduce the
pressure in the cylinder, this is to assist starting the power
cutter. The decompression valve should always be used
when starting. The valve automatically returns to its initial
position when the machine starts.
pressure in the cylinder, this is to assist starting the power
cutter. The decompression valve should always be used
when starting. The valve automatically returns to its initial
position when the machine starts.
•
Stop switch: Make sure that the stop switch (STOP) is in
the left position.
the left position.
•
Start throttle position - cold engine: Start throttle
position and choke is obtained by pulling out the choke
completely.
position and choke is obtained by pulling out the choke
completely.
•
Start throttle position - warm engine: The correct
choke/start throttle setting is obtained by pulling the choke
control to the choke position and then pushing it in again.
This only engages the start throttle setting without any
choke.
choke/start throttle setting is obtained by pulling the choke
control to the choke position and then pushing it in again.
This only engages the start throttle setting without any
choke.
•
Air purge: Press the air purge diaphragm repeatedly until
fuel fills the diaphragm (at least 6 times). The diaphragm
need not be completely filled.
fuel fills the diaphragm (at least 6 times). The diaphragm
need not be completely filled.
Start the engine
•
Grip the front handle with your left hand. Put your right foot
on the lower section of the rear handle pressing the
machine against the ground. Never twist the starter
cord around your hand.
on the lower section of the rear handle pressing the
machine against the ground. Never twist the starter
cord around your hand.
•
Grip the starter handle, slowly pull out the cord with your
right hand until you feel some resistance (the starter pawls
grip), now quickly and powerfully pull the cord.
right hand until you feel some resistance (the starter pawls
grip), now quickly and powerfully pull the cord.
!
WARNING! Please read the operator’s
manual carefully and make sure you
understand the instructions before using the
machine.
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading ”Personal
protective equipment”.
instructions under the heading ”Personal
protective equipment”.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
the working area, otherwise there is a risk of
serious personal injury.
Check that the fuel cap is properly secured,
and that there is no fuel leakage. Risk of fire.
and that there is no fuel leakage. Risk of fire.
!
WARNING! The cutting blade rotates when
the engine is started. Make sure it can rotate
freely.
the engine is started. Make sure it can rotate
freely.
NOTICE! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully
extended. This can damage the machine.
not let go of the starter handle when the cord is fully
extended. This can damage the machine.