Husqvarna 4000 用户手册

Check the engine oil level (A) daily with saw fully lowered and 

the engine level. See the enclosed Kohler manual for more 

details.

Use SAE 10W-30 viscosity detergent automotive type with API 

service class SE or higher grade oil.

Note: Engine holds approximately 2 quart (1.9 liter) when 

changing oil and oil filter.

Inspect the fuel filter (E) every 50 hours. Replace the fuel filter 

annually.

The oil drain hose (D) is located at the front of the saw.

1. With the engine OFF but still warm, remove the brass cap 

and drain the oil in a pan and remove the oil filter (C).

2. Before installing new filter, lightly oil filter gasket with fresh, 

clean oil.

3. Screw filter on by hand until gasket contacts oil filter adapt-

er. Tighten 1/2 to 3/4 turn more.

4. Replace the brass cap on the oil drain hose.

5. Fill the engine at the oil fill cap (B) to the “F” mark on the 

dipstick (A) with 2 quarts (1.9 liters) of oil.

center, or dealer for safe disposal/recycling facility.

Please see the Kohler Operator’s Manual for additional infor-

mation about servicing the engine.

   

The manual also has specific information about specifications, 

tune-up parts, engine warranty, emission compliance, etc.

The air cleaner assembly (F) is accessed on the top of the 

engine. The air cleaner element should be replaced every 50 

hours. Refer to the supplied engine manual and the “Heavy-

Duty Air Cleaner” for additional information.

Check the transmission oil level daily. The transmission is ac-

cessible from the rear of the saw. The oil reservoir (G) located 

on the top of the transmission has an oil level line 1/8” (3 mm) 

from the bottom of the reservoir to indicate the proper fluid 

level when cold. Use hydraulic oil 20W with viscosity of 68 Mo-

bil DTE 26 or equivalent.

With the saw control lever pulled back towards the operator, 

the saw should fully stop and not creep or move. To adjust the 

transmission neutral position, loosen the lock nut on the cable 

end (H) at the transmission. Pull the spring sleeve back and 

adjust the swivel until the saw fully stops moving. Tighten the 

lock nut.