Husqvarna 4000 用户手册

Table of contents   …………………………..  2

Unpacking ..................................................  2

Transporting ...............................................  2
Sound Data ................................................  2

I

ntroduction, personal safety ......................  3 

Registration of the product …………………  4

General safety message ............................  4

Safety warnings .........................................  5

Excel series blades ...................................  6

Blade and skid plate installation ................  6

What is what? ............................................  7

Operating instructions ...............................  8

Fuel and fuel safety warnings …….……....  9

Recommended fuels .................................  9

Recommended oils …….......……….…..…  9

Engine and transmission maintenance .....  10

Other maintenance ………………….……..  11

Sawing contraction joints …………....….…  12

Maximizing the Soff-Cut system .......….....  13

Troubleshooting .........................................  14

Technical specifications .............................  15

Conformity certificates ...............................  15

Warranty ....................................................  16

Your 4000 saw has been shipped from the factory thoroughly 

inspected. Only minimal assembly is required to start using 

the saw. Remove the saw from the container using proper lift-

ing techniques. Discard or recycle the packing material per 

your regional laws. In your container will be the 4000 saw, 

blade shaft wrench, spark plug wrench, an owner’s manual, 

an engine owner’s manual, a part list, a warranty card, a joint 

protector sample pack and a ramp for unloading the saw. Con-

nect the battery cables and turn the key switch to the “ON” or 

“1” position. Press the rocker switch on the instrument panel 

to raise the saw. Place the unloading ramp at the edge of the 

container and roll the saw out of the container. Lower the saw 

and turn the key switch to the “OFF” or “0” position.

Construction Product dealer. 

The 4000 saw weights approximately 454 pounds (206 ki-

lograms) when ready to use . Use safe lifting practices when 

handling the saw. Always remove the diamond blade when 

transporting the saw. Always transport the saw with a skid 

plate installed. Fold the guide arm back. The saw can be lifted 

from the center hook on the roll cage. Always store and trans-

port the saw in a completely lowered position and secured 

from moving.

According to Standard ISO 3744:1998 and Directive 2000/14/

EC for environmental sound level and according to Standard 

ISO 11201:1995 for sound level at the operator’s position, the 

4000 saw emits the following:

 

Sound power level 

Lwa 109 dB (A)   

 

Sound pressure  level  

Lpa  91 dB (A)

Handle bar

Lifting point

Roll cage

Front guide

Rear guide