Husqvarna 4000 用户手册

The Excel Series of diamond blades have been designed specifically for the Soff-Cut Ultra Early Entry dry cutting system of 

green concrete. These specialty blades are designed to increase speed and life while cutting a wide range of aggregates. 

Choose the correct specification of diamond blade for your area as follows:

 

Purple Excel Series 1000   

XL14-1000 

Ultra hard aggregate and non abrasive sand

 

Green Excel Series 2000   

XL14-2000 

Hard to ultra hard aggregate and non abrasive sand

 

Red Excel Series 3000 

 

XL14-3000 

Hard aggregate, medium abrasive sand

 

Orange Excel Series 4000  

XL14-4000 

Medium hard aggregate, medium abrasive sand

 

Yellow Excel Series 5000   

XL14-5000 

Medium hard to soft aggregate, abrasive sand

 

Black Excel Series 6000   

XL14-6000 

Soft aggregate, highly abrasive sand 

Turn the key switch (located on the engine) to the “ON” posi-

tion. Press the rocker switch located in the right handle bar to 

raise the saw to its full height. Turn the key to the “OFF” posi-

tion.
Step 2

Remove the blade block cover (A) by turning the two locking 

knobs counter-clockwise. Insert the blade wrench supplied 

with the saw on the blade shaft bolt (C) on the end of the blade 

shaft in the blade block (I). Rotate the blade shaft counter-

clockwise with wrench on the blade shaft bolt (C) while push-

ing in on the blade shaft locking pin (J) located on the front of 

the saw frame. The locking pin will drop in the blade shaft and 

prevent the shaft from rotating.

Remove the blade shaft bolt by continuing to turn the bolt 

counter-clockwise. Remove the outer arbor washer or flange 

(D).

Match the blade tri-arbor to the blade shaft arbor (F) and install 

the blade firmly against the rear flange (F). Insure the blade is 

installed on the tri-arbor correctly. Match the female tri-arbor of 

the outer washer or flange with the blade shaft and install the 

blade shaft bolt turning clockwise while holding the locking pin 

in. Be sure the outer flange is fully seated and firmly holding 

the diamond blade in position.
Step 5

Install a new skid plate (G) by hooking the front on the front 

blade block shaft pin. Connect the rear blade block shaft and 

the rear of the skid plate by installing the locking pin (B). 

Install the blade cover by turning the two knobs and tighten un-

til fully seated against the blade block. Lift the front and rear of 

the skid plate to insure the blade slides through the skid plate 

freely. 

Insure the lexan shields (E & H) move freely up and down. 

When replacing a worn blade, thoroughly clean the concrete 

from blade block and blade cover before installing the new 

blade. Discard the old skid plate and replace it with a new skid 

plate.

A

C

D

B

F

G

E

H

 

 

 

 

 

 

 

 

I

 

J

 

K