Husqvarna WS 465 用户手册

English

 – 11

4

Turn the blade flange hub carefully so that it slides into 
one of the tracks in the pivot arm and lands in the correct 
position to be screwed fast. 

5

Press in the blade spindle into the cutting arm at the same 
time as the blade is rotated carefully. When the blade 
spindle can no longer be pressed in by hand it should be 
tightened using the supplied 18-spanner until it is properly 
secured (tightening torque 70-80 Nm).

Screw off the outer blade flange and mount the blade on the 
blade flange hub.

A=110 mm/4.33 inch, 6xM10

B=89 mm/3.5 inch, 6xM8

C=144 mm/5.7 inch

1

Slip in the blade guard guide between the stays on the 
blade guard.  Place the blade guard guide in the middle.  
Lock the plastic heel on the handle to the upper stay on 
the blade guard. 

2

Make sure that the pivot arm is positioned vertically.  Lift 
the blade guard over the blade and hang the guard in the 
blade guard holder on the saw. Exercise care so that the 
runners on the blade guard are positioned in the slots on 
the water block.

3

Lock the blade guard by pulling the handle out of the 
guard and then down towards the saw unit so that the 
latch locks the handle.