Husqvarna K650 用户手册
16 –
English
MAINTENANCE
Inspecting and adjusting the drive
belt
belt
•
The drive belt is fully enclosed and well-protected from
dust, dirt and mechanical damage when cutting.
dust, dirt and mechanical damage when cutting.
•
Check the drive belt adjustment by feeling with your
fingers as illustrated. A correctly adjusted drive belt
should have about 5 mm of movement.
fingers as illustrated. A correctly adjusted drive belt
should have about 5 mm of movement.
•
To adjust the drive belt, loosen both the screws (A) holding
the bar one turn anticlockwise.
the bar one turn anticlockwise.
•
Turn the adjuster screw (B) clockwise at the same time as
you feel with your fingers how the drive belt is adjusted.
When there is about 5 mm of movement on the drive belt
this is adjusted correctly and you can then tighten both
screws holding the bar.
you feel with your fingers how the drive belt is adjusted.
When there is about 5 mm of movement on the drive belt
this is adjusted correctly and you can then tighten both
screws holding the bar.
Replacing the drive belt
•
Release the belt tension.
•
Remove the blades.
•
Remove the clutch cover by loosening the screws A and
B.
B.
•
Remove the drive belt from the nose of the cutting arm
(C).
(C).
•
Loosen water hose (E). Slide back the bar and remove the
drive belt around the clutch (D).
drive belt around the clutch (D).
IMPORTANT! A new drive belt must be readjusted after one
or two tanks of fuel have been used.
or two tanks of fuel have been used.