Chicago Electric 42933 用户手册

SKU 42933 

Page 11

secure them by partially tightening 

the two screw clamps built into the 

Base assembly.
Set the Arm (118) assembly column 

6. 

into the Column Base. Move the Arm 

slightly to the left or right until the 

column index knob locks into the arm 

support column. 

The arm support column has nine 

positive stops: 0, 15, 30, 45, and 60° 

(left and right).

7.  Attach the Elevating Handle assem-

bly to the Arm using the Allen wrench 

(provided).

8.  Attach the Saw Blade (17) to the 

Gear Shaft (19) and secure with the 

Outside Flange (16) and Bolt (15). 

Lock the Gear Shaft with the Stopper 

Pin (22) located at the front part of 

the Gear Case Cover (26). 

Using a wrench, tighten the Bolt (15) 

over the Outside Flange (16), coun-

terclockwise.

Place the Safety Guard (10) over the 

9. 

Saw Blade and tighten in place.

10.  Install the anti-kickback pawl on the 

Safety Guard (10) with the pawls fac-

ing the rear of the machine.

11.  Set the height by loosening its lock 

knob and moving it up or down. Re-

tighten again when set to the proper 

height.
Verify that no play exists in the car-

12. 

riage, and that the arm, yoke, and 

bevel locks and clamps are tight.

13.  Slip the Dust Guide (4) over the 

exhaust stem located on the Safety 

Guard.