Haier 232738 用户手册

•

Keep all screws, nuts, washers, gaskets, and 
electrical fittings removed during repair procedures. 
These parts are not normally provided with 
replacement assemblies. 

•

Test  repair after problem is corrected.

•

If sprayer does not operate properly, review repair 
procedure to verify you did it correctly. See Basic 
Troubleshooting, page 9 and Advanced 
Troubleshooting, page 11.

•

Overspray may build up in the air passages. 
Remove any overspray and residue from the air 
passages and openings in the enclosures whenever 
you service the sprayer.

•

Do not operate the sprayer without the enclosure. 
Replace if damaged. Enclosures direct cooling air 
around the motor to prevent overheating. They also 
reduce the risk of burns, fire or explosion. 

Page 4.

Do not run sprayer dry for more than 30 seconds. 
Doing so could damage pump packings.

Protect internal drive parts of this sprayer from 
water. Openings in enclosures allow for air 
cooling of mechanical parts and electronics 
inside. If water gets into these openings, the 
sprayer could malfunction or be permanently 
damaged.

Prevent pump corrosion and damage from 
freezing. Never leave water or water-based paint 
in sprayer when it is not in use in cold weather. 
Freezing fluids can seriously damage sprayer.

Store sprayer with mineral spirits/paint thinner or 
Graco Pump Armor to protect equipment during 
storage.