Graco ti15034a 用户手册

If pump pin works loose, parts could break off due to 
force of pumping action. Parts could project through the 
air and result in serious injury or property damage.

1.

Extend pump piston rod 1.5 in. Apply grease to top 
of pump rod at (A) or inside connecting rod.

2.

Install pump pin (44). Verify retaining spring (43) is 
in groove of connecting rod (85).

3.

Push pump up until pump threads engage.

4.

Screw in pump until threads are flush with drive 
housing opening. Align pump outlet to back.

5.

Install washers, o-rings and suction tube (76) and 
hose (94).

6.

Screw jam nut (56) up onto pump until nut stops. 
Tighten jam nut by hand, then tap 1/8 to 1/4 turn 
with a 20 oz (maximum) hammer to approximately 
75± 5 ft-lb (102 N•m).

7.

Install pump rod shield (108) with screw (31).

8.

Fill packing nut with Graco TSL until fluid flows onto 
top of seal.

If the pump jam nut loosens during operation, the 
threads of the drive housing will be damaged.

ti7171a

A

1.5 in.

ti7169a