Jet Tools JWP-208 用户手册

11

The table rollers are factory set for average 
planing and are parallel to the table surface. If you 
desire to adjust the table rollers higher or lower, 
proceed as follows: 

1.  Disconnect machine from power source. 

2.  Lay a straight edge (B, Fig. 14) across both 

rollers. 

3.  On one side of the table, loosen the screws 

(C, Fig. 14) with a hex wrench, and turn the 
eccentric shafts (D, Fig. 14) to raise or lower 
the rollers. 

4.  When the proper height is achieved, tighten 

screws (C, Fig. 14). 

5.  Adjust the rollers from the opposite side of the 

table in the same manner. 

Important: Be sure that the height of front and 
rear rollers are the same. The table rollers must 
always be set parallel to the table. 

1.  Place a straight edge over the extension roller 

and the table, as shown in Fig. 15, to make 
sure the extension roller and table are at the 
same height. If necessary, adjust the table 
extension rollers as follows: 

2.  Loosen the screws and washers (A, Fig. 15) 

to move the extension roller to the proper 
position, then retighten the screws. 

3.  Adjust both front and rear extension rollers in 

the same manner.