Jet Tools JWP-208 用户手册
8
Handwheel
1. Remove the nut and washer from the gearbox
shaft, and place the handwheel onto the shaft
(Fig. 5), making sure it is oriented so the
handwheel slips over the key.
(Fig. 5), making sure it is oriented so the
handwheel slips over the key.
2. Place flat washer and hex nut on shaft and
tighten with wrench.
3. Mount the handle in the threaded hole in the
handwheel, and tighten with a wrench placed
over the flat on the handle.
over the flat on the handle.
Table Extension Rollers
Mount the table extension rollers to the table using
the provided hex cap screws and washers
(A, Fig. 6). The rollers should be adjusted before
operating the planer; see Adjusting Table
Extension Rollers on page 11.
the provided hex cap screws and washers
(A, Fig. 6). The rollers should be adjusted before
operating the planer; see Adjusting Table
Extension Rollers on page 11.
Dust Collection Hood
The dust collection hood (Fig. 6a) comes standard
with the model JWP-208 planer, and helps
maintain a clean and safe work area. It is
assembled to the planer with the screws and
washers as shown.
with the model JWP-208 planer, and helps
maintain a clean and safe work area. It is
assembled to the planer with the screws and
washers as shown.
Figure 5
Figure 6
Figure 6a