Husqvarna RG 2112 用户手册

•Mandatory

•Indication

•Warning Triangle

•Prohibition

These signs will give advice for your safety.

Before leaving our factory every machine
is thoroughly tested.

Follow our instructions strictly and your machine will give
you long service in normal operating conditions.

1. Features

2. Assembly

3. Check Before Operating

Use: Surface grinding of concrete or other types

of flooring. For repairing horizontal surfaces

that have been damaged by the weather,

or by improper finishing methods, or that

require removal of deteriorated coatings,

overlays, or buildups.

Tools:

1) 2 x 2 x 4” (50 x 50 x 100 mm) size, Six (6) per unit.

In any of the types shown below:

a) Grinding Stones [FIG. 14]

b) Tungsten Carbide Segment Block

[FIG. 16].

c) Tungsten Carbide Impregnated Grinding

Block (Not Shown)

d) Scarifier Blocks (Star, Beam, TC wheels)

[FIG. 27 & FIG. 28].

e) Wire Brushes [FIG. 26].

f) Diamond Blocks [FIG. 15].

2) Multi-Segmented Diamond Disks: Two (2) disks per

unit, 10” (250 mm) diameter, 10 or 20 diamond
segments on each disk [FIG. 24 & FIG. 25].

3) Tool Holding Pad, with “hook-and-loop” type of tool

attachment, holds the following [FIG. 19]:

a) Scrubbing Pad [JJ] [FIG. 19]: Two (2) pads per

unit, 10” (250 mm) diameter, Nylon mesh
Impregnated with Silicon Carbide.

(For information contact your Dealer)

Depth of Cut (Maximum):
See Section 4 (Tool Installation & Application).
Maximum material Size: N/A
Nominal & Operating Weight: See “Specifications”.
Dimensions, Grinding Width, Spindle Shaft RPM:

See “Saw Dimensions”.

Before starting up machine make sure you read
these instructions and are familiar with the
operation of this machine.

The working area must be completely clear, well
lit and all safety hazards removed (no water or
dangerous objects in the vicinity).

The operator must wear
protective clothing appropriate
to the work he is doing.
We recommend hearing,
respiratory and eye protection.

Any persons not involved in the work,
should leave the area.

Only work on flat horizontal areas. Working
on steep slopes or hills could cause the
operator to lose control of the machine.
This could result in injury or death to the
operator or other persons in or near the
work area!

• When unpacked, this unit is fully assembled, except

for installation of the grinding “tools”. For tool
installation See Section 4 of this document.

• The dealer or end user must do the installation of
optional or accessory items, such as a water tank kit.

All Models:

• Take into account the working conditions from

a health and safety point of view.

• For start up refer to the engine, or motor manual.

Electric Models:

The applicable national and local electrical
codes and enforcement bodies will be the
determining authority on the proper connec-
tions and use of this machine. In all cases it
is the operator/owner’s responsibility to ensure
that this equipment is in full compliance with
these codes.