Southbend SB1013 用户手册

-12-

For Machines Mfg. Since 7/09

EVS Toolroom Lathes

Do not attempt to lift or move this lathe if you do 
not have the proper equipment or the necessary 
assistance from other people. All lifting 
equipment must be rated to at least 5,000 lbs. 
to account for dynamic loads from bouncing or 
pulling that may be applied while lifting. Refer 
to the Things You'll Need section on Page 8 for 
details.

  Prepare the permanent location for the 

lathe.

  Remove the shipping crate top and sides, 

then remove the small components from the 
shipping pallet. 

  To balance the lifting load, loosen the 

tailstock lock lever (Figure 5), move the 
tailstock to the end of the bedway, then lock 
it in place.

  To further balance the load, loosen the 

carriage lock bolt (see Figure 6), disengage 
the half nut lever, put the feed control lever 
in neutral, then use the carriage handwheel 
to move the carriage next to the tailstock.

  Position a 12" long 2x6 board under each end 

of the bed, as shown in Figure 7, wrap the 
lifting straps around the bottom of the 2x6's. 

 The 2x6's extend the lifting straps away 

from the bottom of the bed to prevent 
machine damage from excessive strap 
pressure against the leadscrew, feed rod, and 
spindle control rod. Make sure to use them.

12" Long

2x6 Board

Lifting 
Strap

Lathe

Bed

Leadscrew

Feed Rod

Spindle 

Control

 Rod

To Forklift or Lifting Hook