Southbend SB1013 用户手册

For Machines Mfg. Since 7/09

EVS Toolroom Lathes

-45-

The feed direction lever (Figure 81) controls 
direction of the carriage. The quick change 
feed direction knob (Figure 82) reverses the 
feed direction of the carriage while the lathe is 
running.

  While the lathe is running, place the feed 

control lever in neutral.

  Push or pull the quick change feed direction 

knob to change the direction of the feed rod.

  Re-engage the feed direction lever. The feed 

rod rotation will now be reversed, causing 
the engaged carriage or cross slide to move 
in the opposite direction.

  Use the feed control lever on the front of the 

apron to engage power feed for either the 
carriage or the cross slide (see Figure 83). 
To engage the carriage, push the lever to 
the left and down. To engage the cross slide, 
push the lever to the right and up.

 Sometimes you need to slightly rotate the 

handwheel of the component you are trying 
to engage, so that the gears can mesh.

  Make sure the spindle is OFF and has come 

to a complete stop.

  Use the feed direction lever to select the 

direction that the feed rod will rotate.

 The feed rod rotation will be the reverse of 

what is shown on the control panel diagram 
if the quick change feed direction knob is 
engaged.