Yard Machines 41AD-280G000 用户手册

ENGINE WILL NOT START

ENGINE WILL NOT IDLE

ENGINE WILL NOT
ACCELERATE

ENGINE LACKS POWER
OR STALLS WHEN UNDER
LOAD

CUTTING ATTACHMENT
WILL NOT ADVANCE LINE

On/Off Stop Control in the STOP
position

Empty fuel tank

Primer bulb wasn't pressed enough

Engine flooded

Old or improperly mixed fuel

Fouled spark plug

Air Filter is Plugged

Old or improperly mixed fuel

Improper carburetor adjustment

Old or improperly mixed fuel

Improper carburetor adjustment

Old or improperly mixed fuel

Improper carburetor adjustment

Cutting attachment bound with
grass

Cutting attachment out of line

Inner reel bound up

Cutting head dirty

Line welded

Line twisted when refilled

Not enough line is exposed

Turn the On/Off Stop Control to START

Fill fuel tank

Press primer bulb fully and slowly 5-7
times

Use starting procedure with choke 
control in the RUN position

Drain fuel tank / Add fresh fuel mixture

Replace or clean the spark plug

Replace or clean the air filter

Drain fuel tank / Add fresh fuel mixture

Refer to MAKING ADJUSTMENTS,
Section 5.

Drain fuel tank / Add fresh fuel mixture

Refer to MAKING ADJUSTMENTS,
Section 5.

Drain fuel tank / Add fresh fuel mixture

Refer to MAKING ADJUSTMENTS,
Section 5.

Stop the engine and clean cutting
attachment

Refill with new line

Replace the inner reel

Clean inner reel and outer spool

Disassemble, remove the welded sec-
tion and rewind the line

Disassemble and rewind the line

Push the Bump Knob and pull out line
until 4 inches (102 mm) of line is out-
side of the cutting attachment