Ryobi Outdoor ZRRY41002 用户手册

Page 15

n

    Wind the line counterclockwise around the spool fol-

lowing arrows on spool. Do not overfill.
NOTE: After winding the line, there should be about 6 
in. (152 mm) between the wound line and the outside 
edge of the spool.

n

    Secure the line temporarily by pushing it into one of 

the slotted tabs on the spool.

n

    Repeat the process for the lower threaded area of the 

spool, winding the line counterclockwise and securing 
it in the slotted tab opposite the first secured line.

n

    Insert the lines into the eyelets in the trimmer head.

n

    Place the spool on the drive shaft.

NOTE: To install the spool, you may need to rotate 
it slightly. 
NOTE: If the line should tangle or break at the eyelets, 
remove the spool, refeed the line through the eyelets, 
and reassemble the spool on the trimmer.

n

    Release the lines from the tabs by sharply pulling each 

line while pushing down on the spool.

n

    Push down on the spool to reveal the threads on the 

drive shaft. 

n

    Place the retaining cap on the threads inside the drive 

shaft.

n

    Secure the retaining cap by turning it clockwise.

            

An improperly installed retaining cap or spool could 
fly off the trimmer. Contact with a thrown retaining 
cap or spool could cause personal injury.

See Figure 14.
The spool may wear during normal use of the line advance 
feature and may require occasional replacement. Replace-
ment spools are available through your local retailer.
n

    Release the trigger.

n

    Unplug the trimmer.

Make sure the trimmer head stops rotating. Contact 
with a rotating trimmer head could cause personal 
injury.

n

    Remove  the  retaining  cap  by  turning  it  counter-

clockwise.

n

    Remove the empty spool.

n

    Clean the trimmer head thoroughly. Inspect the trim-

mer head for any damaged or worn parts.

Fig. 14

n

    Hold the spool so that its tabbed side is positioned 

upward.
NOTE: On the new spool, the ends of the lines are 
secured  in  slots  on  tabs.  Release  the  line  from  the 
tabs,  unwind  approximately  six  inches  of  line,  and 
re-secure the lines in the tabs.

n

    Insert the lines on the new spool into the eyelets in 

the trimmer head.

n

    Place the spool on the drive shaft.

NOTE: To install the spool, you may need to rotate 
it slightly. 
NOTE: If the line should tangle or break at the eyelets, 
remove the spool, refeed the line through the eyelets, 
and reassemble the spool on the trimmer.

n

    Release the lines from the tabs by sharply pulling each 

line while pushing down on the spool.

n

    Push down on the spool to reveal the drive shaft. 

n

    Place the retaining cap on the drive shaft.

n

    Secure the retaining cap by turning it clockwise.