Ryobi Outdoor ZRRY41002 用户手册

Page 9

Fig. 3

Fig. 2

See Figure 2.
The coupler connects the attachment to the upper shaft. 
Follow these steps to connect the attachment to the up-
per shaft.
n

    Loosen the knob by turning it counterclockwise.

n

    Remove the end cap from the attachment shaft.

n

    Align the button with the guide recess on the upper 

shaft.

n

    Slide the attachment shaft into the upper shaft until 

the attachment shaft clicks into place.
NOTE: If the button does not release completely in 
the positioning hole, the shafts are not locked. Slightly 
rotate the attachment shaft until the button is locked 
into place.

n

    Tighten the locking knob securely by turning it clock-

wise. 
NOTE: During operation, periodically check the knob 
and tighten as necessary.

See Figure 2.
Disconnect the upper shaft and attachment shaft for stor-
age or when a job calls for a different attachment.
Follow  these  steps  to  remove  the  attachment  from  the 
upper shaft.
n

    Release the trigger and allow the trimmer to coast to 

a stop.

n

    Unplug the trimmer.

n

    Loosen  the  locking  knob  by  turning  it  counter-

clockwise.

n

    Push the button, while pulling out the attachment.

See Figure 3.
Follow these steps to attach the front handle.
n

    Press the front handle onto the upper shaft so that the 

handle is angled toward the trigger handle. 

n

    Place the front handle along the upper shaft to a posi-

tion that allows for comfortable operation. 

n

    Slide the bolt through the holes in the front handle.

n

    Slide the washer onto the bolt.

n

    Place the wing nut onto the bolt and tighten the wing 

nut securely.