Husqvarna 80792 用户手册

12

NOTE: Operating with trimmer line of
uneven length will cause excessive
vibration. Always make sure the line is
wound evenly and trimmed to equal
lengths from the eyelets.

INSTALLATION INSTRUCTIONS

72414-15100*
Fits F18, F21, F230
72086-15100
Fits LT18, T18, T20, C20, LT20,
T230, C230, 22T
72031-15100
F20

72005-92600
Fits T25, C25, T27, C27, BP35, T250,
C250, T260, C260, T270, C270, T350
99909-151
Fits C35, B45, RC45, C350, B450

Shipped with 21 feet
of .095 line.
Maximum fill–

26 feet of .095
20 feet of .105

Midget Manual
72414-15100
72086-15100
72031-15100
Shipped with 14
feet of .080 line.
Maximum fill–

26 feet of .080
6 feet of .095

Remove the wing nut knob and spring
(turn counterclockwise to remove on
72414-15100; turn clockwise on all
others).

Remove the line spool.

Clean the spool, housing and eyelets.
Inspect for wear and damage, and
replace damaged components.

Reattach the eyelets (if they were
removed). Never run a trimmer head
without eyelets!

Replace the line by threading through
the eyelet in the spool until the line
ends are of equal length. Refer to the
Line Chart (above) for the proper
amount of line.

Bend the line at spool eyelet to form
two lengths. 72414-15100: Wind both
ends clockwise as viewed from the
underside of the head. All others:
Wind counterclockwise.