Husqvarna EA 850 用户手册

 

English

 

 – 

 

7

Fit the bevel gear on the shaft. Turn the cutter so that the shaft 
engages in the bevel gear.

Position the bevel gear so that the slot aligns with the line on 
the shaft.

Firmly tighten the screw.

Fit the cutter as follows:

1

Fit the drive disc (A) on the output shaft. Make sure that 
the edge that engages in the hole in the cutter is facing 
outwards.

2

Prevent the cutter from rotating by inserting the locking pin 
in the hole behind the cutter guard, so that it engages it in 
the corresponding hole in the drive disc.

3

Place the cutter (B) on the drive disc.

4

Fit the support flange (C). The support flange must be 
fitted so that its outer edge presses against the cutter.

5

Fit the locking nut (D). CAUTION! The locking nut has a 
left-hand thread. Tighten the locking nut to a torque of 35-
50 Nm.

6

Remove the locking pin.

CAUTION! Do not forget to remove the locking pin before 
using the machine.