Husqvarna 965966702 用户手册

English

 –

 11

1151387-49 Rev.2 2009-06-10

•

Clip the loop handle onto the shaft. Note that the loop 
handle must be fitted between the arrows on the shaft.

•

Slide the spacer into the slot in the loop handle.

•

Fit the nut, washer and screw. Do not overtighten.

•

Now adjust the trimmer to give a comfortable working 
position. Tighten the screw.

•

Fit the correct trimmer guard (A) for use with the 
trimmer head. Hook the guard onto the fitting on the 
shaft and secure it with the bolt (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

To fit the trimmer head, first separate the two halves 
(see diagram). Proceed as follows:

•

Insert a finger into the centre hole of the cover (I) while 
grasping the cover with your other fingers. Using the 
index finger and thumb of your other hand, release the 
two catches (J) that engage in the cut-outs in the 
bottom half (K). Pull apart the trimmer head, grasping 
the cover firmly.

•

Place the cover (I) and the support flange (F) on the 
output shaft. Ensure that the drive disc’s guide locates 
correctly in the cover’s centre hole.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 
the spanner in the opposite direction to the direction 
of rotation (Caution! left-hand thread).