Husqvarna 426LST 用户手册
ASSEMBLY
10 – English
Fitting the loop handle
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
must be mounted below the arrow on the shaft.
•
Slide the spacer into the slot in the loop handle. Fit the
nut and screw. Tighten.
nut and screw. Tighten.
Assembling the cutting
equipment
equipment
Fitting the trimmer guard and
trimmer head
trimmer head
•
Fit the correct trimmer guard (A) for use with the
trimmer head.
trimmer head.
•
Tighten the two screws.
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head (D) in the opposite
direction to the direction of rotation.
direction to the direction of rotation.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
A
H1153174-95,426LST,430LS,US.fm Page 10 Monday, November 30, 2009 10:56 AM