Husqvarna 323C 用户手册

12 – 

English

•

Position the handle on the shaft. Note that the handle 
must be mounted below the arrow on the shaft.

•

Fit the screw, securing plate and wing nut as shown in the 
diagram.

•

Tighten the wing nut.

•

Clip the loop handle onto the shaft. Note that the loop 
handle must be fitted between the arrows on the shaft.

•

Slide the spacer into the slot in the loop handle.

•

323L: Fit the nut, washer and screw. 

325Lx/325LDx: Fit the nut, knob and screw. Do not 
overtighten.

•

Now adjust the trimmer to give a comfortable working 
position. Tighten the bolt/knob.

•

Make sure the knob is loose.

•

Align the cut-out in the lower part of the shaft with the 
coupling locking tab on the upper part of the shaft. Then 
lock the sections together.

•

Tighten the knob.

•

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the lower half of the shaft to unlock it.

•

Hold both parts of the shaft and pull the lower part of the 
shaft out of the coupling.

When fitting the cutting attachment it is extremely important 
that the raised section on the drive disc/support flange 
engages correctly in the centre hole of the cutting attachment. 
If the cutting attachment is fitted incorrectly it can result in 
serious and/or fatal personal injury.