Husqvarna 250 R 用户手册

下载
页码 48
English
 – 33
MAINTENANCE
Air filter
The air filter must be regularly cleaned to remove dust and dirt 
in order to avoid:
Carburettor malfunctions
Starting problems
Loss of engine power
Unnecessary wear to engine parts
Excessive fuel consumption.
Clean the filter every 25 hours, or more regularly if conditions 
are exceptionally dusty.
Cleaning the air filter
240R, 240F
Remove the air filter cover and take out the filter. Wash it 
clean in warm, soapy water. Ensure that the filter is dry before 
refitting it. 
If the machine is used in dusty conditions the air filter should 
be soaked in oil. See instructions under the heading Oiling the 
air filter.
250R, 252RX
Remove the air filter cover and remove both filters, A and B. 
A is an air filter and B is a pre-filter. Both must be washed in 
warm soapy water and dried. Filter A must then be soaked in 
oil, see instructions under the heading Oiling the air filter.
265RX
Remove the air filter cover and take out the filter. Wash it 
clean in warm, soapy water.
Ensure that the filter is dry before refitting it. 
Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The 
filter oil contains a solvent to make it spread evenly through 
the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it. 
Knead the plastic bag to distribute the oil. Squeeze the 
excess oil out of the filter inside the plastic bag and pour off 
the excess before fitting the filter to the machine. Never use 
common engine oil. This would drain through the filter quite 
quickly and collect in the bottom.
An air filter that has been in use for a long time cannot be 
cleaned completely. The filter must therefore be replaced with 
a new one at regular intervals. A damaged air filter must 
always be replaced.
Bevel gear
The bevel gear is filled with the right quantity of grease at the 
factory. However, before using the machine you should check 
that the bevel gear is filled three-quarters full with grease. Use 
HUSQVARNA special grease.
The grease in the bevel gear does not normally need to be 
changed except if repairs are carried out.
B
A