Kolpak DA-98 用户手册
Section 14 – Maintenance and memory setups
06/97 – 1.00 – 14-3
3) Within menu group F, move the cursor so that
it is by the
Dr search
field. The number of
whole hours that the head has been in use for
fast forward and fast rewind will be shown on
the bottom line of the display.
fast forward and fast rewind will be shown on
the bottom line of the display.
14.2 Memory backup
The DA-98 includes non-volatile memory
(NVRAM) which preserves almost all user set-
tings after the power is turned off.
(NVRAM) which preserves almost all user set-
tings after the power is turned off.
14.3 User setups
You can save commonly-used setups in one of
three user setup memory banks: 1, 2 or 3. This
enables you to pre-configure the DA-98 for differ-
ent jobs (video or film post-production, or differ-
ent recording setups, for example). There is also a
preset memory bank which contains the factory
settings (see below).
three user setup memory banks: 1, 2 or 3. This
enables you to pre-configure the DA-98 for differ-
ent jobs (video or film post-production, or differ-
ent recording setups, for example). There is also a
preset memory bank which contains the factory
settings (see below).
When the DA-98 is shipped, the contents of all
setup memories are the same; they contain the fac-
tory settings.
setup memories are the same; they contain the fac-
tory settings.
14.3.1 Saving user setups
1) Go to menu group 9, move the cursor to
Setup
and press
ENTER
:
2) To store the current setup, use the
UP
and
DOWN
keys so that the bottom line reads
Save
:
3) Move the cursor to
1
,
2
or
3
, and press the
UP
or
DOWN
key:
4) The word
Ready?
will flash on the screen. To
save the current setup to the selected setup
memory, press the
memory, press the
UP
or
DOWN
key.
The word
Done
will appear on the screen for
about 2 seconds and the user settings will be
stored to the selected setup memory bank.
stored to the selected setup memory bank.
14.3.2 Loading user setups
1) Go to menu group 9, move the cursor to
Setup
and press
ENTER
:
2) To load the setup memory into the current
memory, use the
UP
and
DOWN
keys so that the
bottom line reads
Load
:
3) Move the cursor to
1
,
2
or
3
, and press the
UP
or
DOWN
key:
The word
Done
will appear on the screen for
about 2 seconds..
The contents of the currently-selected setup will
be loaded into memory.
be loaded into memory.
S y s
v e r
F r o n t
v e r
S e r v o
v e r
S y n c
v e r
D r
t o t a l
D r
s e a r c h
0 0 0 2
S e t u p
L o a d
1
2
3
F
S e t u p
S a v e
1
2
3
S e t u p
R e a d y
?
S a v e
1
2
3
S e t u p
L o a d
1
2
3
F
S e t u p
L o a d
1
2
3
F
S e t u p
R e a d y
?
L o a d
1
2
3
F