Winegard TR-3535 产品宣传页

ONE TIME ASSEMBLY: Remove contents from carton.  
Assemble each of the three legs by inserting the leg 

extension into the attached leg until the leg extension locks 

into place. See Figure 1.

1. Set all three legs to the 

desired position by pinching the 

tabs holding the legs in place 

and moving the leg extension 

until it locks into the desired 

position. 
2. Set up tripod in an area 

with a clear view of the sky — 

south west or south-southeast, 

depending on your location in 

the continental U.S.
3. Place bubble level on top of 

mount pipe and loosen the lock 

knobs on the adjustable legs. 
4. Slide the legs towards or 

away from the center of the unit 

until the tripod is level. 
4.  After leveling, tighten the 

lock knobs and remove bubble 

level.

ELEVATION ANGLE
Depending on your location, satellites will be at an elevation 

angle between 30° and 60°. Southern states point more 

toward 60°, northern states point more toward 30°.
FINDING THE SATELLITE
1. Be sure to connect the cables to the TV, receiver and 

antenna before accessing satellite signal, and connect to 

your power source.
2. Check the instruction manual that came with your 

receiver to determine how to access the on-screen signal 

meter.
The signal meter shows you when you have locked onto 

a satellite broadcast signal and gives the signal strength. 

Be sure you select your type of dish antenna — pointing     

coordinates will depend on the type of dish you have.
3. 

your location. Enter into your receiver menu.
4. Rotate compass dial until azimuth value aligns with the 

blue arrow.
5. Turn compass to align red pointer arrow to red “N”.
6. Point satellite dish in same direction as the blue arrow.
TO STORE THE TR-3535
1. Remove the reflector.
2. Loosen the leg bracket knobs and collapse the three 

legs into the folded position. 
3. Pinch the tabs holding the leg in the extended position 

and slide the leg extension back into the leg until it locks in 

the storage position. See Figure 3.
4. Tighten the knobs and store the tripod.

5. Slide satellite antenna* 

onto pole and secure it 

to the pole. Use ground 

stakes to stabilize mount if 

necessary. 
See Figure 2.

BUBBLE LEVEL

MOUNT PIPE

KNOB

LEG

 

BRACKET

SCREW, 14 X ½ AB

TRIPOD LEG

 

 

PIVOT FOOT

STAKE

TR-3535 IN FOLDED 
POSITION

PUT STAKE THROUGH
HOLE IN LEG BRACKET,
PUSH INTO GROUND