Havis-Shields CD-CL-HID-1 产品宣传页

 

CD-CL-HID-1_INST_12-07 

•  Reinstall the reflector, and align it properly.  Clean the reflector if necessary with 

residue-free glass cleaner and a soft, lint-free cloth.   

•  Clean the glass lens, and place it on top of the reflector.  The glass will directly hold 

the reflector in place. 

•  Wrap the lens gasket around the housing and lens.  The gasket will hold the lens and 

fixture together.  Ensure it is clean and placed properly before proceeding. 

•  Replace the lensframe by first pressing one end into the lens gasket.  Make sure the 

tab is oriented properly before pressing it in firmly.  Start pressing at the tab, and 
work the lensframe into the gasket by pressing firmly every couple of inches along 
the lensframe until the entire lensframe is seated properly.  It is important to press in 
sequence, starting from the first tab and working all the way around the lensframe.  
The last place to press is the second tab, and the two lensframe tabs should meet 
closely when the lensframe is installed properly.  Replace the lensframe screw and 
nut, and tighten them securely.    

 

 

 
 

 

•  In the event of improper operation, first use a voltmeter to ensure that the fixture is 

receiving adequate input power.  CD-CL-HID-1 fixtures require 12VDC for proper 
operation.  If the voltage is too low, the lamp may fail to light or restrike.  If the 
voltage is too high, the ballast and lamp can fail prematurely.  Correct any faults 
found.   

•  If no electrical faults are found, then either the ballast or lamp may require 

replacement.  Always replace the lamp first, especially if it is an old lamp.   

•  If the fixture fails to light after replacing the lamp, then replace the ballast as well.   

•  A new lamp should normally be installed whenever a new ballast is installed.   
•  If necessary, contact Havis-Shields for additional troubleshooting procedures.