Vector VEC118S 用户手册

1. Locate the recharge port on the side of the spotlight (see figure 1). 
2. Connect the charger to an appropriate AC power source. 
3. Plug the charger's barrel connecter into the recharge port located near the

handle. Note that the red LED lights to indicate that the battery is charging. 

4. Recharge for 12 hours maximum.
5. After recharge, disconnect the adapter from the external charging source, then

disconnect barrel connector from the recharge port.

6. After AC recharge, wait 5 minutes before using spotlight.
Recharging from an AC source requires the use of the AC/DC recharge adapter.
NOTE:

DO NOT OPERATE THE SPOTLIGHT DURING AC RECHARGE. Make 

sure the AC outlet provides 110 to 120 VAC at 60 Hz. 
CAUTION:

Use the supplied AC recharge adapter; do not substitute with 

any other.
FIGURES 2A & 2B 

- AC AND DC RECHARGING ADAPTERS

Plug the DC recharge/power adapter (included) into the DC accessory socket on 

the front of the spotlight body, and then insert the power cord into the 12 Volt 

DC power outlet socket of your vehicle or other 12 Volt DC power source. The 

spotlight may be operated while the internal batteries are being charged. Allow

approximately 8 hours charging time. Recharge for the recommended time.

Make sure the DC source (jump starter, battery pack, vehicle accessory socket,

etc) is 12 Volt DC. For corded operation, the DC source should be able to supply

at least 10 amps at 12Volt DC. 

AC RECHARGE ADAPTER

BARREL CONNECTOR

DC PLUGS

DC RECHARGE ADAPTER