Husqvarna K3000 用户手册

English

 – 13

•

The guard for the cutting equipment should be adjusted so 
that the rear section is flush with the work piece. Spatter 
and sparks from the material being cut are then collected 
up by the guard and led away from the user.

•

Feed down the machine in line with the blade. Pressure 
from the side can damage the blade and is very 
dangerous.

The word kickback is used to describe the sudden reaction 
that causes the power cutter and cutting blade to be thrown 
from an object when the upper quadrant of the blade, known 
as the kickback zone, touches an object.

•

Never start to cut with the upper quadrant of the blade as 
shown in the figure, also known as the kickback zone.

•

Always hold the machine in a firm grip with both hands. 
Hold it so that the thumbs and fingers grip round the 
handles.

•

Keep a good balance and a firm foothold.

•

Always cut at maximum speed.

•

Stand at a comfortable distance from the work piece.

•

Take care when inserting the blade in an existing cut.

•

Never cut above shoulder height.

•

Be alert to movement of the work piece or anything else 
that can occur, which could cause the cut to close and 
pinch the blade.

Pull in occurs when the disc’s lower section suddenly stops or 
when the cut closes. (To avoid, see the heading ”Basic rules” 
and ”Jamming/rotation”, here below.)

If the cut is pressed together this can lead to jamming. The 
machine can be pulled down suddenly with a very powerful 
jerk.

Support the work piece in such a way that the cut remains 
open during the cutting operation and when the cut is 
finished.