Samsung C61RAAST 用户手册

 

 

Important: Be sure the new appliance is installed and grounded only by qualified 

personnel.

 

 Please observe this instruction. The warranty will not cover any damage that may 

occur as a result of improper installation.

 

Technical data is provided at the end of this manual.

This appliance meets the following standards:
•  EN 60 335 - 1 and EN 60 335 - 2 - 6, relating to the safety of electrical appliances for house-

hold use and similar purposes;

•  EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric cook-

ers, hobs, ovens, and grills for household use;

• EN 55014 - 2;
• EN 55014;
• EN 61000 - 3 - 2; and
• EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC).
 

This appliance complies with the following EU Directives:

 

• 73 / 23 / EWG dated 19.02.1973 (Low Voltage Directive);

 

•  89 / 336 / EWG dated 03.05.1989 (EMC Directive including Amending Directive 92 

/ 31 / EWG); and

 

• 93 / 68 / EWG CE Labeling Directive.

•  A device must be provided in the electrical installation that allows the appliance to be discon-

nected from the mains at all poles with a contact opening width of at least 3 mm. Suitable 

isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed 

from the holder), earth leakage trips and contactors.

•  With respect to fire protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of 

appliance may be installed with a high cupboard or wall on one side.

• Drawers may not be fitted underneath the hob.
• The installation must guarantee shock protection.
•  The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 

68930.

• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
•  On tiled work surfaces, the joints in the area where the hob sits must be completely filled with 

grout.

•  On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place 

with a suitable artificial resin or mixed adhesive.

•  Ensure that the seal is correctly seated against the work surface without any gaps. Additional 

silicon sealant must not be applied; this would make removal more difficult when servicing.

• The hob must be pressed out from below when removed.

C61RAAST_XSA-00045A-01_EN.indd   5

2008-04-21   ｿﾀﾈﾄ 5:04:05