Whirlpool W10682797A 保修信息

The Cycle Status Lights show the progress of a cycle.  

At each stage of the process, you may notice sounds or 

pauses that are different from traditional washers.
 SENSING/FILL
  When the START/Pause button is pressed, the washer 

will fill to an initial water level and begin sensing to 

determine the load size. If the lid is closed when 

the washer is done sensing, the lid will lock and the 

washer will continue filling to begin operation. The lid 

will remain locked for the rest of the cycle unless the 

cycle is Paused or Cancelled.

  If the lid is open when the water stops entering the 

washer, the cycle will not begin until the lid has been 

closed and the START/Pause button is pressed. If the 

cycle has not been started within 10 minutes of the 

water filling the washer, the washer will pump out the 

water.

Avoid opening lid during sensing phase. The 

sensing process will start over when the washer is 

restarted. The Sensing/Fill light may also come on 

during the Soak and Wash portions of the cycle. This 

is normal. To restart the washer after the lid has been 

opened press START. 

 

  You will hear the motor and agitator moving the load. 

During the first stage of the sensing/wash cycle, 

water will partially fill the washer and then begin to 

move the load. It is normal to have the sensing light 

on during this stage. You will hear the agitator rotate, 

followed by a several second pause. This process will 

repeat for several minutes, allowing the entire load to 

become saturated. The lower water level combined 

with HE detergent at this stage allows for concentrated 

cleaning. Concentrated cleaning delivers the detergent 

directly to the soils. It is normal for the load to be 

above the water line during this stage. At the beginning 

of the second stage, the washer will add water to the 

correct level based on the load size. You will hear the 

agitator move quicker during this stage of the wash 

cycle. The motor sounds may change at different 

stages in the wash cycle.  

You will hear sounds similar to the wash cycle as the 

washer rinses and moves the load. You may hear 

the motor turning on briefly (short hum) to move the 

basket while filling. 

The washer spins the load at increasing speeds for  

proper water removal, based on the selected cycle  

and spin speed. 

Once the cycle is complete, this light will come on.  

Remove the load promptly for best results. 

 LOCKED 

  

To allow for higher spin speeds, the  

lid will lock and the Locked light  

will turn on. When this light is lit, the  

lid is locked and cannot be opened. 

When this light is blinking, the washer  

is paused. When this light is off, the lid  

can be opened. 

After a cycle is started, water will  

enter washer. Lid will be unlocked  

during the Sensing/Fill process. If  

you need to open the lid to add a  

garment after this point, you must  

press START/Pause and wait for the  

lid to unlock. The lid will only unlock after washer 

movement has stopped. Depending on where in the 

cycle you try to pause, it may take several seconds 

to several minutes for the lid to unlock. Press START/

Pause to resume the cycle.