Whirlpool ADG 750 用户手册
19
Tension adjustment
of the door spring
of the door spring
【
】
Figure5
Tension adjustment of the door spring
●
Connection of drain hoses
●
The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust the door spring tension. Rotate the
adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5).
wooden panel are installed, you will have to adjust the door spring tension. Rotate the
adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Door spring tension is correct when
t he door remains horizontal in the
f ully o pened position
t he door remains horizontal in the
f ully o pened position
yet rises
t o a close with the slight lift of a
f inger.
f inger.
Lj
relax
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. Use the spe ial
plastic support that comes with the appliance (figure 6). The free and of the hose
must be at a height between 400 and 1000mm and must not be immersed in water
to avoid the back flow of it. ATTENTION: The special plastic hose support must be
solidly fastened to the wall to prevent the drain hose from moving and allowing water
to spill outside the drain.
run into the sink, making sure to avoid bending or crimping it. Use the spe ial
plastic support that comes with the appliance (figure 6). The free and of the hose
must be at a height between 400 and 1000mm and must not be immersed in water
to avoid the back flow of it. ATTENTION: The special plastic hose support must be
solidly fastened to the wall to prevent the drain hose from moving and allowing water
to spill outside the drain.
c
Drain pipe connection
【Figure6】