Cecilware VAE-J1 用户手册

espresso coffee machine  -  instructions for the user

18

  -  english

R

To ensure perfect safety and efficiency of the machine over time, it is necessary to carry out routine, preventive and special maintenance. In 
particular, it is advisable to carry out an overall check of the machine at least once a year. 

Periodically check the following items:
•  check the pump pressure with a gauge which should indicate a value of between 8 and 9 bar. In case of malfunctions, request the assi-

stance of technical service;

•  still using the pressure gauge, check that the boiler pressure is roughly 0.8-1.2 bar. The assistance of technical service may also be 

required in this case;

•  check the condition of the filters for any damage along the edges and see if there are any coffee grounds in the cup. If necessary replace 

the filters.

Periodically check the following items:
•  check the dose, which should be about 6-7 g. per stroke and adjust the amount;
•  always monitor the degree of grinding and modify as required;
•  check the condition of wear of the grinders. They must be replaced when there is too much powder  in the ground coffee (the grinders 

have a life cycle of approximately 600 kg of coffee).

Perform the following steps on a weekly basis:
•  perform regeneration of the softener as described in chapter 9 (for the manual softener version);
•  check that there is salt in the appropriate container (for the version with automatic softener);
•  check the LEDs come on properly (anti-lime scale system version)
 

 

 

 

 

- green LED 

system OK

 

 

 

 

 

- red LED  

system partially out of order (*)

 

 

 

 

 

- LED off  

system completely out of order (*)

 

 

 

 

 

(*) request assistance from technical service

Special care is advised when cleaning the cappuccino maker. Follow these instruc-
tions:
•  wash initially by immerging the suction tube in water and then dispensing for 

a few seconds;

•  turn the rotating body (1) 90° to pos. B (milk outlet tube closed);
•  hold the milk suction tube in the air. Release the steam (dry run of cappuccino 

maker);

•  wait about 20 seconds to allow for of the cappuccino maker;
•  shut off the steam and place the rotating body back in pos. A;
•  if the air intake hole is clogged (2), carefully unclog it with a pin.