Roland VR-3 用户手册

Names of Things and What They Do

fig.audio-mix-section.eps

Use the [GAIN] dials to adjust the input sensitivity for 
channels 1 through 4. When the volume level exceeds the 
maximum input level, the corresponding [PEAK] indicator 
lights up. Excessive input volume may result in clipping or 
distortion. Set the [GAIN] dials for adequate audio level 
without clipping.

Use the [Hi] dials to emphasize or attenuate the high band. 
Use the [Lo] dials to emphasize or attenuate the low band.

These adjust the stereo position of the respective channels.

These faders adjust the amount of signal being sent from 
each channel and the amount of signal each channel sends 
to the final output (MASTER).

This adjusts the audio level for USB output.

This adjusts the level for headphones output.

This adjusts the level for the internal microphones.

This displays the audio output level. If [OVER] lights up, 
distortion might occur. Turn down the [MASTER] level if the 
[OVER] indicator lights up.

This adjusts the level of audio input coming from a computer 
connected to the [7/8] connector on the rear panel.

This adjusts the amount of reverb applied to output.

This adjusts the level for final output.

Audio Mixer Section