3M 800a3 用户手册
18
7-INSTALLATION (continued)
2011 September
800a3-NA
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks
frame and remove the polystyrene blocks
(Figure 7-4).
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame (Figure 7-5).
EMERGENCY STOP cable to the frame (Figure 7-5).
Cut the plastic ties holding the lower taping head in
position (Figure 7-6).
position (Figure 7-6).
7.6 Assembly Completion
1 Crank - Install the crank handle on the top of
the left column as shown
the left column as shown
(Figure 7-7A).
2 Tape Drum Bracket - Install the upper tape
drum bracket on the top cross bar as shown
drum bracket on the top cross bar as shown
(Figure 7-7B).
3 Stop Bracket - Raise upper head assembly
(turn crank handle counterclockwise) and install
the two stop brackets (provided in the parts
bag). Use lower set of holes as shown in
(turn crank handle counterclockwise) and install
the two stop brackets (provided in the parts
bag). Use lower set of holes as shown in
Figure 7-7D. The upper set of holes should only
beused when both taping heads are adjusted to
apply 50mm tape legs.
apply 50mm tape legs.
Figure 7-4
Figure 7-5
Figure 7-6
Figure 7-7
A
C
B
D