Behringer 2442FX 用户手册

XENYX 1622FX/1832FX/2222FX/2442FX User Manual

XENYX 1622FX/1832FX/2222FX/2442FX User Manual

wired in a balanced configuration. In case of doubt, contact 

the microphone manufacturer!

SERIAL NUMBER
Please note the important information on the serial number 

given in chapter 1.3.3.

The packaging of your mixing console contains two 19" rack 

mounts for installation on the side panels of the console.
Before you can attach the rack mounts to the mixing 

console, you need to remove the screws holding the left 

and right side panels. Then, use these screws to fasten the 

two rack mounts, each specifically to one side. With the 

rack mounts installed, you can mount the mixing console 

in a commercially available 19" rack. Be sure to allow for 

proper air flow around the unit, and do not place the mixing 

console close to radiators or power amps, so as to avoid 

overheating.

You will need a large number of cables for the various 

connections of the console. The illustrations below show the 

wiring of these cables. Be sure to use only high-grade cables.

Fig. 6.1: Foot switch connector

Please use commercial RCA cables to wire the 2-track inputs 

and outputs.
You can, of course, also connect unbalanced devices to 

the balanced input/outputs. Use either mono plugs, or use 

stereo plugs to link the ring and shaft (or pins 1 & 3 in the 

case of XLR connectors).

Fig. 6.2: XLR connections

The footswitch connects both poles momentarily

For unbalanced use, pin 1 and pin 3 have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 6.3: 1/4” mono plug

Fig. 6.4: ¼" stereo plug

Fig. 6.5: Insert send/return stereo plug

Fig. 6.6: Stereo plug for headphones connection

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Connect the insert send with the input and the

insert return with the output of the effects device.