Blomberg FINE 1531P 用户手册
EN
7
3
Installation
TRANSPORTATION
INSTRUCTIONS
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
frontof the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. When positioning your appliance
take care not to damage your flooring,
pipes, wall coverings etc. Do not move
the appliance by pulling by the door or
handle.
IMPORTANT : Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal support or pipework
at the back of the appliance as you
might injure your fingers and hands or
damage your product..
I
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
frontof the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. When positioning your appliance
take care not to damage your flooring,
pipes, wall coverings etc. Do not move
the appliance by pulling by the door or
handle.
IMPORTANT : Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal support or pipework
at the back of the appliance as you
might injure your fingers and hands or
damage your product..
I
MPORTANT : This appliance is not
designed for stacking with any other
appliance.
appliance.
When positioning your appliance, take
care not to damage your flooring,
pipes,wall coverings etc.
Do not attempt to sit or stand on top of
your appliance as it is not designed for
such use. You could injure yourself or
damage the appliance.
“IMPORTANT: Make sure that mains
cable is not caught under the appliance
during and after carrying / moving the
appliance, to avoid the mains cable
becoming cut or damaged.”
Do not allow children to play with the
appliance or tamper with the controls.
BLOMBERG declines to accept any
liability should the instructions not be
followed.
care not to damage your flooring,
pipes,wall coverings etc.
Do not attempt to sit or stand on top of
your appliance as it is not designed for
such use. You could injure yourself or
damage the appliance.
“IMPORTANT: Make sure that mains
cable is not caught under the appliance
during and after carrying / moving the
appliance, to avoid the mains cable
becoming cut or damaged.”
Do not allow children to play with the
appliance or tamper with the controls.
BLOMBERG declines to accept any
liability should the instructions not be
followed.
INSTALLATION
INSTRUCTIONS
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or
in direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
3. This appliance has been designed
to operate in ambient temperatures up
to 32 degrees C (90 degrees F) and
is equipped with Advanced Electronic
Temperature Control System [AETCS]
which ensures that at the advised
setting [4 - four on the knob] the frozen
appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or
in direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
3. This appliance has been designed
to operate in ambient temperatures up
to 32 degrees C (90 degrees F) and
is equipped with Advanced Electronic
Temperature Control System [AETCS]
which ensures that at the advised
setting [4 - four on the knob] the frozen