Hoshizaki DCM-750BAH-OS 补充手册

5

8) Replace spout A, spout B, and the front cover of the storage bin in their correct 

positions.

9) Move the power switch to the "ON" position, then replace the panels in their correct 

positions.

0) Turn on the power supply, then move the control switch to the "ICE" position to start the 

automatic icemaking process. 

) Move the control switch to the "DRAIN" position and drain all of the water from the 

evaporator. 

) After the water has stopped draining, move the control switch to the "OFF" position, 

then turn off the power supply. Remove the front and top panels, then move the power 
switch to the "OFF" position.

3) Remove the front cover of the storage bin. Remove spout B, then remove spout A. 

See Fig. .

4) Remove the apron panel, then remove the left side panel.
5) Remove the extruding head heater, then remove the allen head cap screws securing 

the extruding head. Using the cutter, lift out the auger assembly. 

6) Remove the cutter, extruding head, and upper part of the mechanical seal from the 

auger and place them on the new auger. 

7) Install the new auger assembly with the upper part of the mechanical seal attached and 

tighten down the allen head cap screws.

8) Replace the extruding head heater in its correct position.
9) Replace spout A, spout B, and the front cover of the storage bin in their correct 

positions. 

0) Move the power switch to the "ON" position, then replace the panels in their correct 

positions.

) Turn on the power supply, then move the control switch to the "ICE" position to start the 

automatic icemaking process.

Always install a new drier every time the sealed refrigeration system is opened. 
Do not replace the drier until after all other repair or replacement has been 
made. 

) Move the control switch to the "DRAIN" position and drain all of the water from the 

evaporator.

) After the water has stopped draining, move the control switch to the "OFF" position, 

then turn off the power supply. Remove the front and top panels, then move the power 
switch to the "OFF" position.